Installation Instructions

	Clutch Side (For Throttle Side, please follow your manufacturer's recommended installation specifications.) NOTE: Always test throttle response before attempting to ride.

			Remove old grip. Make sure to remove all oils, glues, etc. from handle bars.

			Remove one side of tape protector and apply tape to handle bar.

			Remove second side of tape protector to expose adhesive.

			Measure clutch housing distance with grip length. Adjust housing after grip is installed.

			Pour water inside of grip and shake. Pour out all water from inside of grip over the entire piece of tape. Shake grip to remove any remaining water.

			Slide grip over tape. Adjust clutch housing (if necessary) to match grip length.

			Let stand for at least 2 hours for tape adhesive to dry. Make sure it is secure before attempting to ride.

Sponsorships: